The Art of Adhesion: Using Hot Glue as a Medium

This is the core technique that differentiates this method. Hot glue acts as a fantastically clear, quick-setting adhesive and encasement. The goal is to encapsulate the flowers without burning them or creating unsightly bubbles and strings.

1. 🔥 Prepping the Glue Gun

Plug in your glue gun and allow it to fully heat up. If using a low-temp gun, wait for the glue to become fully molten and transparent. Work on a clean, protected surface. Have a damp cloth nearby to quickly wipe any accidental glue drips from the pull's surface before it sets.

2. 🍯 Applying the First Anchor Layer

Apply a very small dot of hot glue to the back of your central or largest pressed flower. Using tweezers, immediately place it onto the pull base according to your design photo. Hold it gently for a few seconds until the glue sets. Repeat this process, building your arrangement from the bottom layer up (e.g., leaves first, then larger flowers, then tiny accents).

3. 🌊 Creating the Protective Dome

Once all elements are securely anchored, it's time to create the clear, glass-like dome. Slowly and steadily, apply a generous bead of hot glue around the outer edge of your floral arrangement. Then, carefully fill in the center, allowing the glue to flow naturally over the flowers. The goal is to completely submerge them in a smooth, convex layer of glue. Avoid going over the same spot repeatedly, as this can introduce air bubbles.

4. 💨 Managing Bubbles and Strings

If small air bubbles appear, you can often pop them with the tip of a pin or the hot nozzle of the glue gun immediately after application. To manage glue strings, make sure your sealing pass is confident and continuous. After finishing, quickly pass a heat source (like the glue gun nozzle held *near*, not touching) over the surface; the residual heat will melt away fine strings.